Kitchen and bathroom remodel electrical
If you're remodeling a kitchen or bathroom around Waco or Woodway, the electrical work is the part I want you to get right the first time. I own League Electric, and our crew handles the circuits, lighting, and code items that make a remodel actually work.
Why this part of the remodel matters
Cabinets and tile get all the attention, and I get it. But if the circuits behind the wall aren't right, you find out later: a breaker that trips when the microwave and the toaster run, a GFCI that isn't where it should be, or a pretty light that no one can switch from the door you actually use.
The good news is that when the walls are open, this work is cleaner and usually simpler. We can add outlets where you'll use them, run lighting the way you want it, and fix old surprises before the drywall goes back up.
What a kitchen remodel usually needs
Every kitchen is a little different, but around here the list often looks like this. Enough outlets on the counters, with the right protection near the sink and wet areas. Dedicated circuits for bigger appliances. Lighting over the island, the sink, and the work areas, not just one lonely fixture in the middle of the ceiling. Under-cabinet lighting if you want it, which is much easier before the cabinets are tight to the wall.
If you're putting in a range or a cooktop, that usually means a 240-volt circuit sized for the appliance. Same idea for a lot of electric dryers in a nearby laundry room. We look at the nameplate on the new appliance and at your panel before we promise a path.
Older Waco bungalows and mid-century homes in Woodway and Hewitt weren't wired for today's kitchens. You may have a mix of original wiring, a 90s addition, and a half-finished island circuit. We'll sort out what can stay and what needs to be redone, and I'll tell you that straight before we start.
What a bathroom remodel usually needs
Bathrooms are smaller, but they're picky. Outlets near the sink need proper GFCI protection. A fan that actually vents, on a switch that makes sense. Lighting at the mirror so you can see, and a fixture in the room that isn't an afterthought. If you're adding a bigger shower or moving the vanity, the wiring has to move with it.
This is also a good time to replace a worn switch or a rusty fixture box, and to make sure the circuit isn't shared with something it shouldn't be. None of that is exciting. All of it is the difference between a bathroom that works and one that keeps tripping a breaker.
Your builder, your cabinet guy, and our crew
If you already have a contractor, we'll work with them. We'll help line up the schedule, and our crew will show up when the job is ready for electrical — usually a rough-in while the walls are open, then a finish pass when fixtures and devices go in. If you're running the remodel yourself, walk us through the plan, even if it's a sketch on graph paper.
What I need from you is pretty simple: where the appliances go, how you want the lights to switch, and any must-haves (an outlet for a coffee station, a fan on a timer, a dimmer over the table). If you don't know yet, we can talk it through at the house.
Permits, inspections, and older homes
New circuits, moved circuits, and panel work generally need a permit and an inspection. Simple like-for-like swaps often do not. Inside Waco city limits that runs through the City of Waco. In Woodway it's the City of Woodway. Some addresses on the edge of town fall under a different jurisdiction, and we confirm that for your property.
If we pull the permit, we handle the paperwork and meet the inspection. I'd rather do it that way than have a surprise show up when you sell the house. You can read more about how we work in Waco and right here in Woodway, where our shop sits on Broad Ave.
If the panel is part of the conversation
A remodel is often when we find a panel that's already full, a fuse box, or an older panel brand we don't like to leave in place. I'll tell you if that's the case. Sometimes a small subpanel solves it. Sometimes the right move is a panel upgrade first, then the kitchen or bath work. We won't bury that in the middle of the job.
League Electric is family-owned, licensed in Texas (TECL #32044), and insured. The crew has 55 years of combined experience, and a master electrician is on the team. We treat your house like a neighbor's, because around here it usually is.
Ready when you are
If you're in the planning stage, that's the best time to call. Send a few photos, a floor plan if you have one, and a rough idea of the finish date. We'll come look and give you a straight estimate.
Call us at (254) 327-1844, Monday through Saturday, 6:30 to 5. Or book online or send a note. We're happy to take a look.
What’s included
- Kitchen remodel circuits, outlets, and appliance hookups
- Bathroom remodel electrical, including GFCI protection and fans
- Lighting, under-cabinet lighting, and dimmers
- Coordination with your builder or a homeowner-led remodel
- Permit and inspection handling when the job requires it
- Homes in Waco, Woodway, Hewitt, and nearby towns
Serving Waco & nearby
Looking for kitchen and bathroom remodel electrical near you? League Electric is a family-owned electrician in Waco, TX and an electrician in Woodway, TX, with a master electrician on the team.
Waco · Hewitt · Robinson · Bellmead · Woodway · Lacy-Lakeview · McGregor · China Spring · Lorena
FAQs
Do I need a licensed electrician for a kitchen or bathroom remodel in Waco?
If you're adding or moving circuits, or doing more than a simple fixture swap, yes. New circuits and panel work generally need a permit and an inspection. League Electric is licensed in Texas (TECL #32044) and we handle that paperwork when the job requires it.
Can you work with my contractor?
Yes. We do rough-in while the walls are open and a finish pass when the fixtures and devices go in. We'll help line up the schedule with your builder.
Will my panel need to be upgraded for a kitchen remodel?
Not always. We check the panel first. If it's full, it's a fuse box, or it's an older brand we recommend replacing, we'll tell you before the remodel electrical starts.
Do bathrooms and kitchens need GFCI outlets?
Yes. Outlets near sinks and other wet areas need proper GFCI protection. We build that in as part of the remodel, and we can add it to an existing kitchen or bath too.
Do you remodel kitchens and bathrooms in Woodway and Hewitt too?
Yes. Our shop is on Broad Avenue in Woodway, and we regularly do this work in Waco, Woodway, Hewitt, Robinson, and the towns around them.